20.25N.050 Dimensional requirements.
|
Maximum Impervious Surface (6) |
Maximum Lot Coverage (6) |
||||
|---|---|---|---|---|---|
|
Front (5) |
Rear |
Side |
|||
|
20′ |
25′ |
20′ |
65% |
40% |
30′ |
Notes:
(1)Setbacks shall be measured from the exterior boundaries of the entire area contained in the approved MDP.
(2)Maximum building height in CCC districts is 30 feet measured from the average elevation of the existing grade around the building to the highest point of a flat roof, or 35 feet to the ridge of a pitched roof. Shoreline height is measured per LUC 20.25E.080.
(3)Maximum building height of any individual building façade is 40 feet measured from the existing grade at the building wall to the ridge of a pitched roof or top of a flat roof.
(4)An increase in building height, including any building façade, of up to a maximum 55 feet (to a pitched or flat roof) is allowed for specific uses as identified in the Master Development Plan and the requirements noted below:
(a)Such height increase is approved under both the Master Development Plan and Design Review for the structure; and
(b)Rooftop mechanical equipment shall be subject to the height limitations in LUC 20.25B.040.A.1; and
(c)The increase in height is necessary to accommodate uses or equipment functionally related to a permitted CCC use such as swimming pools, performing arts theatres, and gymnasiums; and
(d)Any portion of the structure exceeding the maximum building height is stepped back from any property line a minimum distance of 50 feet unless a reduction is approved through the Master Development Plan process.
(5)The front yard setback for retail/service/commercial uses is zero feet. These uses are subject to LUC 20.25N.080.D, Building Design Guidelines – Retail/Service/Commercial Uses.
(6)Maximum impervious surface and maximum lot coverage shall be based on the total site area contained in the approved MDP.
(Ord. 6190, 11-3-14, § 1)